Levelit tile leveling kit | 2 mm | 250 pcs

For rectified wall tiles and ceramic floor tiles in dry indoor areas, 1 to 2 mm is often chosen to achieve a clean, modern joint appearance.

In living spaces, bathrooms and kitchens, both wall and floor, 2 to 3 mm is the most universal choice, as it provides sufficient tolerance for size variations, substrate movement and moisture exposure.

For natural stone, large-format tiles, underfloor heating, high-traffic areas and outdoor applications, 3 to 5 mm clips are recommended to properly accommodate expansion, contraction and load stress.

Step 1: Determine the size of your tile (length × width in cm).

Step 2: Locate this size in the table on the left: the X-axis represents one side of the tile and the Y-axis the other side. At the intersection of both measurements, you will find the number of clips per m².

Step 3: Multiply this value by the total number of square metres you will be tiling. The result is the total number of clips required.

Tip: It is recommended to add an extra 5–10% as a safety margin for cutting waste and spares.

Step 1: Always have enough adhesive and place the first tile. Make sure the first tile is completely level.

Step 2: Slide the clip(s) under the tile and tap the tile. Place the next tile after you have applied the clips. Place this tile on top of the clip base.

Step 3: Slide the wedge through the opening of the clip. Use the leveling plier to push the wedge through the clip with enough force until the tile is level. TIP: Do not remove the wedge yet.

Step 4: Leave the wedge in place for less than 24 hours after fixing and once the tile adhesive has hardened, the clip and wedge can be easily removed with a rubber mallet or your foot. TIP: Always break in the direction of the joint.

Step 5: Remove the wedges from the spacer clips, they can be reused.